MR-DMS直流信号报警DC signal alarm setter
[MR-RMS] RTD temperature alarm setter (2alarm)
[MR-PMS] Potentiometer alarm setter (2alarm)
[MR-TMS] Thermocouple alarm setter (2alarm)
[MR-DMS4] DC signal alarm setter (4alarm)
[MR-RMS4] RTD temperature alarm setter (4alarm)
This is a converter used for requiring contact output in response of high & lower setting values at 2points by inputting DC signal.
FEATURES Small size(mm) : 83(H), 51(W), 102(D). Isolation : input to output to power supply. Power supply : AC or DC supply. Wiring : terminal socket wiring. Case & color : black ABS plastic case. Weight : about 400g MR - DMS INPUT SIGNAL SPECIFICATION OUTPUT SIGNAL SPECIFICATION Output type : dry contact or specify. Output range : 120VAC @ 1A, 30VDC @ 1A. Dead band : 1% of full scale. GENERAL SPECIFICATION'S Operating ambient temperature : 0 - 50'C. Non operating ambient temperature : -20 ~ 80'C. Temperature coefficient : 0.015%/'C. Operating ambient humidity : 90% RH max.(non condensing) Insulation resistance : greater than 100Mohm with 500VDC. Dielectric strength : 1500VAC @ 1minute (input to out1 to out2 to power). Adjustment range : 0 - 100% (low & high). Conversion accuracy : 0.2% max. Response time : 0 - 90%(0.5sec). Dead band error : 1% max. Input voltage signal : -300 ~ 300VDC Input voltage impedance : 1Mohm min. Input current signal : 30mADC max. Input current load resistance : 100ohm max. (at 20mA) DISPLAY Type : 3 digit FND Display font : red super bright Display function's : input or percent(%). Display error : 1digit(LSB). DISPLAY SIGNAL 1 : Input signal 2 : Percent(%) OUTPUT SIGNAL 1 : Dry contact 2 : Specify ALARM SET CONTACT INPUT SIGNAL DC SIGNAL 2(+), 3(-) L > INPUT < H L < INPUT < H L < INPUT > H L > INPUT > H LOW SET DRY CONTACT 5(B), 6(C), 7(A) ON OFF OFF ON HIGH SET DRY CONTACT 8(A), 9(C), 10(B) OFF OFF ON ON This is a converter used for requiring contact output in response of high & lower setting values at 2points by inputting DC signal.
|